EFRD Hot-Tap Control System
Operate
Manual
Settings
System Status
Pipe Size
6"
12"
24"
36"
48"
IDLE - READY
Cut Progress
0 deg 0 / 370 deg 370 deg
Sequence
IDLE PLUNGE CONTACT CLAMP CLEAR CUT RE-ENGAGE RETRACT HOME
Controls
Run Time 00:00
Est. Cut Time --:--
Cutter Motor
0.0 A
020 A
Feed Motor
0.0 Hz
060 Hz
Vibration
0.0 mm/s
025 mm/s
VFD 1 - Cutter
StatusStopped
Frequency0.0 Hz
Current0.0 A
VFD 2 - Feed
StatusStopped
Frequency0.0 Hz
Current0.0 A
Plunge Driver
PositionHOME
Hex SeatedNo
MotorOff
ActuatorIdle
Safety & Environment
E-StopOK
ClampReleased
Housing PSI0
Oil Temp22 C
Cutter Amps - Trend
Event Log
System ready - select pipe size and press START
Pipe Size Selection
6"
12"
24"
36"
48"
Active Profile 6" Pipe - Schedule 80
6" Pipe - Cutting Parameters
Cutter Speed Hz
Feed Speed Hz
Plunge Search RPM RPM
Plunge Work RPM RPM
Wall Thickness mm
Current Thresholds
Resume Limit %
Warning Limit %
High Limit (Stop) %
Drive Rated Amps A
Contact Current A
Vibration Thresholds
Warning Level mm/s
Critical Level mm/s
Timing & Timeouts
Plunge Timeout sec
Retract Timeout sec
Comms Loss Timeout sec
Est. Cut Duration min
Actions
MANUAL MODE - Individual motor control. Operator is responsible for safe operation.
VFD 1 - Cutter Motor
Speed 0 Hz
Status Stopped
Current 0.0 A
VFD 2 - Feed Motor
Speed 0 Hz
Status Stopped
Current 0.0 A
Plunge Driver - Automatic Cycle
Status Idle
Position HOME
Hex Seated No
Plunge operates as automatic sub-cycle: extends, finds socket, turns screw to contact, then stops. Retract reverses screw and retracts to home.
Safety
E-Stop OK
Clamp Released
Live Readings
0.0 A
0Cutter Amps
Environment
Vibration0.0 mm/s
Housing PSI0
Oil Temp22 C
DC Bus325 V
Manual Mode Log
Manual mode ready